Grimmspeed Manual Boost Controller Manual de usuario

Busca en linea o descarga Manual de usuario para Para El Coche Grimmspeed Manual Boost Controller. GrimmSpeed Manual Boost Controller User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 4
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Grimmspeed
1
GrimmSpeed Manual Boost Controller
Installation Instructions
Manual 300016 RevA
All GrimmSpeed products are intended for Off-Road use only.
Warning (read before installing):
Before moving forward with the setups outlined below, insure that you have the experience
and confidence to properly tune your car. If not, please consult a tuning professional.
Without a proper tune you can overboost and damage your engine.
Under no circumstances is the GrimmSpeed Manual Boost Controller to be used in any
applications where failure of the valve to operate as intended could jeopardize the safety of
the operator or any other person or property.
NOTE: You MUST run a boost gauge to properly tune the Manual Boost Controller. Raising your
boost level may destroy your engine if you raise it too high without proper tuning.
A. Basics
Our boost controller works by interrupting the pressure seen by the wastegate. If you were
running no boost controller and your turbo was outputting 15psi then your wastegate would
also be seeing 15psi. By placing our boost controller in between the pressure source and
wastegate you are able to limit the amount of pressure that makes its way to the wastegate,
thus you are able to efficiently increase boost pressure. Many OEM wastegates are only able
to handle low psi, however with our boost controller, your vehicle will be able to produce
much higher boost levels than your wastegate would normally allow.
Vista de pagina 0
1 2 3 4

Indice de contenidos

Pagina 1 - Grimmspeed

Grimmspeed 1 GrimmSpeed Manual Boost Controller Installation Instructions Manual 300016 RevA All GrimmSpeed products are intended for Off-Road

Pagina 2

Grimmspeed 2 B. Installation 1. Attach supplied mounting bracket to manual boost controller using a 3mm hex wrench. 2. Find a proper location in

Pagina 3

Grimmspeed 3 4. Remove hose from wastegate actuator. 5. And remove the hose from the pressure side of the turbo. 6. Connect the pressure sourc

Pagina 4

Grimmspeed 4 8. Connect the wastegate actuator to the outlet of the manual boost controller with the supplied vacuum line. The outlet side of the ma

Comentarios a estos manuales

Sin comentarios